• liquid
• Immediate further processing
• Elastic adhesive joint
• waterproof

Description

Non-drip, universal contact adhesive which, due to its gel-like consistency, enables uniform, clean and economical application.

Very suitable for working on vertical surfaces and for overhead work. Materials can be processed immediately after bonding. Strong and clean, for extreme loads.

Permanently elastic: compensates for material stresses, therefore ideal for flexible foam materials.

Instruction manual

Parts must be clean, dry and free of grease. Coat both surfaces thoroughly. Allow the adhesive to dry for at least 10 – 40 minutes. For porous materials, apply a second coat and allow to dry. Connect the parts and roll or tap them firmly together (with a rubber mallet).
Please note

For best results, the adhesive and the parts to be bonded must be joined at room temperature (do not use below 10 °C under any circumstances). The amount of final strength depends on the applied pressure. Therefore, please press the entire surface as firmly as possible. If the adhesive bond of two porous materials is in contact with water for a long period of time, the adhesive may detach from the wet surface.
Stains/Residues

Remove fresh adhesive residues immediately with acetone. Test on a non-visible area beforehand. Dried adhesive residues can only be removed mechanically or with a paint remover (test first).
Storage conditions

Store tightly closed in a cool and frost-free place. Shelf life at least 24 months.